Psion Teklogix PrintAbout MP2000 Spécifications télécharger pdf (Page 7)

Selecting Emulations

The emulations offered by Printer Mobile Thermal Printers allow for a great deal of language commonality

between the various series of Psion Teklogix printers as well as compatibility with systems and software that

have been created for printers offered by other manufacturers.

The Psion Teklogix PTX Print Series printers offer Printek, O’Neil, ZPL-II and CPCL emulations to allow the

printers to work with existing three inch applications.

The printer’s default emulation, Printek, may be selected through the control panel set up as described in the

printer’s Operator’s Manual. To select an emulation temporarily, the host system may send an escape sequence

as described below.

Select Emulation ESC ESC n

This command selects emulation mode n by which future commands will be interpreted as described in the

following table. The selected mode will be in effect until another Select Emulation command is received or

until the printer is reset via an escape sequence appropriate for the current emulation, or the printer is manually

reset by entering/exit the front panel set up mode or cycling power on the printer.

Once the emulation has been selected, please refer to the section of this manual that describes the commands

available for that emulation.

Example: The following escape sequence will set the printer to Mt3 Emulation.

Escape Sequence: ESC ESC 4

Hexadecimal: 1B 1B 04

Emulation

0 Test (reserved for factory use)

1 Printek Emulation

2 O’Neil Emulation

3 ZPL-II Emulation

4 Mt3 Emulation

5 CPCL Emulation

6 Hex Dump Mode

? Previously Selected Emulation

@ Default Emulation

If more than one emulation has been selected, ESC ESC ? will return to the previously selected emulation. This

is particularly useful when the previous emulation is unknown. Please beware that the memory (stack) is only

one level deep.

ESC ESC @ will return to the default emulation, as specified by the “Emulation” value in the Interface setup

menu.

Note: Numeric values may be specified as either a binary or an ASCII value. As such, the example above

may be sent as either 1B 1B 04 or 1B 1B 34.

1 2 3 4 5 6 7 8 9 10 11 12 ... 60 61

Pas de commentaire

Psion Teklogix PrintAbout MP2000 Spécifications Page 7