Psion Teklogix 9160 G2 Manuel d'utilisateur Page 195

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 436
  • Table des matières
  • DEPANNAGE
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 194
Chapter 16: Configuring 802.11 Radio Settings
Configuring Radio Settings
Psion Teklogix 9160 G2 Wireless Gateway User Manual 171
Fragmenta-
tion Threshold
Specify a number between
256
and
2,346
to set the frame size threshold in bytes.
The
fragmentation threshold
is a way of limiting the size of packets (frames) transmitted over the network. If
a packet exceeds the fragmentation threshold set here, the fragmentation function will be activated and the
packet will be sent as multiple 802.11 frames.
If the packet being transmitted is equal to or less than the threshold, fragmentation will not be used.
Setting the threshold to the largest value (
2,346
bytes) effectively disables fragmentation.
Fragmentation involves more overhead both because of the extra work of dividing up and reassembling of
frames it requires, and because it increases message traffic on the network. However, fragmentation can help
improve
network performance and reliability if properly configured.
Sending smaller frames (by using lower fragmentation threshold) may help with some interference problems;
for example, with microwave ovens.
By default, fragmentation is
off
. We recommend not using fragmentation unless you suspect radio interference.
The additional headers applied to each fragment increase the overhead on the network and can greatly reduce
throughput.
RTS Threshold
Specify an
RTS Threshold
value between
0
and
2347
.
The RTS threshold specifies the packet size of a request to send (
RTS
) transmission. This helps control traffic
flow through the access point, especially one with a lot of clients.
If you specify a low threshold value, RTS packets will be sent more frequently. This will consume more band-
width and reduce the throughput of the packet.
On the other hand, sending more RTS packets can help the network recover from interference or collisions
which might occur on a busy network, or on a network experiencing electromagnetic interference.
Maximum
Stations
Specify the maximum number of stations allowed to access this AP at any one time.
You can enter a value between
0
and
2007
.
Table 16.1 Radio Settings
Field Description
Vue de la page 194
1 2 ... 190 191 192 193 194 195 196 197 198 199 200 ... 435 436

Commentaires sur ces manuels

Pas de commentaire