Psion Teklogix 7525C Spécifications télécharger pdf

1. Preparation

Note: This RFID reader installation instruction sheet applies to the following WORKABOUT PRO

model numbers: 7525C and 7527S.

Warning: The installation of this RFID PCMCIA Card must be performed using the appropriate anti-

static devices. If such devices are unavailable, discharge static from your body by touching a

grounded metallic object before

opening any covers on the unit.

Important: The WORKABOUT PRO does not support hot-swapping of PCMCIA Cards. All power

sources must be switched off before a card is inserted in the unit.

The RFID Reader kit consists of a PCMCIA Card, an antenna cable, an antenna mounted in an end-cap, plus a

mechanical stop to secure the card inside the unit.

Figure 1 Contents Of The Kit

The PCMCIA Card slides into the PCMCIA slot in your WORKABOUT PRO. It can be used alongside the built-in

Bluetooth radio. The end-cap replaces the existing end-cap on your WORKABOUT PRO.

For detailed information on operation and specifications, please refer to the WORKABOUT PRO Hand-Held

Computer User Manual for your unit.

2. Installation

To install the RFID Reader:

Important: Back up any data in RAM first, since it will be erased when the unit is turned off.

1. If your WORKABOUT PRO is using AC power, disconnect it.

2. Remove the WORKABOUT PRO battery pack.

3. Slide the hardware power switch inside the battery compartment to switch off internal battery-backup

power:

Figure 2 Switching Internal Battery-Backup Power Off

4. Remove the end-cap at the top of the WORKABOUT PRO. Use a #1 Phillips screwdriver on the four

screws.

Mechanical Stop

Screws For Mechanical Stop

RFID Decoder Card

End-Cap Containing Antenna

On The S Version

OFF

On The C Version

WORKABOUT PRO RFID READER WA9900-G2 INSTRUCTIONS

April 15, 2008

8100171 Rev. A Sheet 1 of 3

1 2 3 4

1. Preparation 1
2. Installation 1

Résumé du contenu

Page 1 - 2. Installation

1. PreparationNote: This RFID reader installation instruction sheet applies to the following WORKABOUT PRO model numbers: 7525C and 7527S.Warning: The

Page 2

5. Install the Psion Teklogix PCMCIA Expansion Module kit, model WA9101-G1 (not included) in the WORKABOUT PRO. This provides the connector for the PC

Page 3

10. Attach the end-cap. Figure 7 Attaching The End-Cap11. Tighten the 4 end-cap screws to a torque of 3 lb-in (0.34 N·m).12. Slide the hardware power

Page 4

Plus de documents pour Stations d'accueil pour appareils mobiles Psion Teklogix 7525C

Voir le document Psion Teklogix 7525C Manuel d'utilisateur

Psion Teklogix 7525C Manuel d'utilisateur (364 pages)

Psion Teklogix 7525C Manuel d'utilisateur (396 pages)

Commentaires sur ces manuels

Pas de commentaire

Psion Teklogix 7525C Spécifications

Naviguer en ligne ou télécharger Spécifications pour Stations d'accueil pour appareils mobiles Psion Teklogix 7525C. Psion Teklogix 7525C Specifications Manuel d'utilisatio

Résumé du contenu

Plus de documents pour Stations d'accueil pour appareils mobiles Psion Teklogix 7525C

Commentaires sur ces manuels

Produits connexes et manuels pour Stations d'accueil pour appareils mobiles Psion Teklogix 7525C